Petey the Parrot at the Bay Area Maker Faire 2014

by Roy Worthington

Petey the Parrot and his maker Dave Sidley were at the Bay Area Maker Faire, May 17th & 18th at the San Mateo CA Event Center.

Dave made Petey almost entirely on an Afinia H479 3D Printer. There are 31 parts and it takes about 32 hours to print them. 

For more details and a short story about Dave and Petey, visit www.cheddarmoon.com

EXPO HALL BOOTH 126

Petey - The 3D Printed parrot Puppet
Petey - The 3D Printed Parrot Puppet
Petey - The 3D Printed Parrot Puppet
Petey - The 3D Printed Parrot Puppet
Petey - The 3D Printed Parrot Puppet
Petey - The 3D Printed Parrot Puppet
Petey - The 3D Printed Parrot Puppet
Petey - The 3D Printed Parrot Puppet
Petey - The 3D Printed Parrot Puppet
Petey - The 3D Printed Parrot Puppet
Petey - The 3D Printed Parrot Puppet

This article was published on .